Get 4A0-265 Dumps : Verified Nokia Optical Diagnostics and Troubleshooting Exam

A unidirectional amplification stage works by boosting the incoming optical signals by the ingress amplifier, while the outgoing optical signals do not pass through the ingress amplifier. This means that the ingress amplifier only amplifies the signals in one direction, hence the name unidirectional. This configuration is typically used for point-to-point links or ring networks where bidirectional amplification is not required or desired1. References : Nokia Optical Diagnostics and Troubleshooting Course | Nokia

In bidirectional configurations, where the same fiber is used to transmit signals in both directions, power adjustments can be performed at both ingress and egress amplifiers. The ingress power adjustments are performed against the ingress amplifiers, which boost the incoming signals from the opposite direction. The egress power adjustments are performed against the egress amplifiers, which boost the outgoing signals from the same direction2. Therefore, the statement A is correct. References : Nokia Optical Diagnostics and Troubleshooting Course | Nokia, Optical amplifiers, explained by RP; optical amplification

When troubleshooting possible generic fiber cuts, the recommended first step is to review alarms at nodes where power loss occurs. This can help identify the location and extent of the fiber cut and the affected services. The next recommended step is to perform network power traces to attempt to determine the point of power loss. Network power traces are graphical representations of the optical power levels along a span or a path. They can be used to compare the measured power levels with the expected power levels and to pinpoint any significant deviations or drops that indicate a fiber cut. The other options are incorrect because they either do not help locate the fiber cut or are not as effective as network power traces. References: Nokia Optical Diagnostics and Troubleshooting Course, OAM and Diagnostics Guide

The exhibit shows a graph of optical power levels measured at different interfaces throughout the optical path of a single wavelength. The different colored green columns indicate the optical power levels at different points along the optical path, such as the transmitter, the receiver, and the amplifiers. The graph also shows the expected power levels and the allowed deviation range for each point. The graph can be used to monitor the performance and quality of the optical signal and to identify any potential issues or anomalies. The other options are incorrect because they either describe a different type of graph or do not match the exhibit. References: Nokia Optical Diagnostics and Troubleshooting Course, OAM and Diagnostics Guide

The statement that best describes the Forward Error Correction (FEC) technique is C. FEC is a technique used in digital communication to improve the accuracy and reliability of data transmission. By adding redundant information to the transmitted data, FEC enables the receiver to detect and correct errors without retransmission or other error correction techniques11. FEC is effective only above a specified OSNR threshold, which is the minimum optical signal-to-noise ratio required for error-free transmission with FEC enabled. If the OSNR falls below this threshold, FEC cannot correct all errors and data quality degrades significantly. References : Nokia Optical Diagnostics and Troubleshooting Course | Nokia, Optical User Guide - Nokia, Forward Error Correction (FEC) - Online Tutorials Library