AP0-001 Practice Exam Questions with Answers Acme Packet Certification Exams Boot camp & Braindump Certification

The notify berpd force command was issued.

The standby Net-Net 4000 did not receive a heartbeat packet within the configured advertisement time.

A failure decremented the heath score below a configured threshold.

The CPU utilization exceeded 90%.

the saved configuration file has been edited, but the done command was not issued

the saved configuration file has been copied from flash into SDRAM using the save-config command

the saved configuration file has been saved into flash, but the activate-config command has not been issued

the saved configuration file was copied from flash into SDRAM using the activate-config command

sub-port-id

name

unique-id

identifier

503 Service Unavailable messages are never generated by the Net-Net 4000.

A 503 Service Unavailable will be originated when the Net-Net 4000 is unable to forward a request due to session agent constraint or lack of bandwidth.

The Net-Net 4000 will originate a 503 Service Unavailable when it has no call processing resources.

By default, when the Net-Net 4000 has reached 95% CPU utilization, it will originate 503 Service Unavailable responses for all calls.

network processor

host processor

CAM

traffic management subsystem

The node that had the role of active last.

The node that had the role of standby last.

The node with the highest Wancom IP address.

The node with the lowest Wancom IP address.

There are two fans, each with configurable speed control.

The fan module is field upgradeable.

The fan speed is automatically adjusted to the appropriate level based on the current operational status and system environment.

The fan module can move the air a total of 30 cubic feet per minute.

maximum 8 FE ports or 4 GE ports

maximum 4 FE ports or 2 GE ports

maximum 16 FE ports or 8 GE ports

maximum 2 FE ports or 1 GE ports

You must have a minimum of three realms in any configuration as one realm must be designated as the home realm.

All endpoints within a realm must reside within the same subnet as the Net-Net 4000.

Although you can use both TCP and UDP concurrently as the transport protocol, you can only have one SIP-interface per realm.

You can associate multiple realms with a single network interface.

Use the exec last-known good config command

Use the rollback command

Use the restore-backup-config command

None of the above

sec-utility-address

pri-utility-addr

ip-address

arp-address

send traffic to the device configured in the sec-gateway field

decrement its health score to 50 which may result in a failover to the standby

use the Virtual Router Redundancy Protocol (VRRP) to determine a new default gateway

use the Virtual Router Redundancy Protocol (VRRP) to the host(s) instead of the primary gateway

Establishment, modification and termination of multimedia sessions.

Provides resource reservation for multimedia sessions.

Supports redirection services.

Describes the supported media attributes for the session.

tunnel signaling messages over the H.245 connection

establish a separate TCP connection to tunnel messages

tunnel H.245 messages over H.225.0 FACILITY messages

support the Generic Tunneling Protocol (GTP) for sending SIP messages over the H.245 connection

nat-interval

nat-traversal

registration-interval

nat-mode

sd400p9.gz

/tffs0/sd400p9.gz

/boot/sd400p9

/boot/sd400p9.gz