Black Friday Flash Blitz - 75% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 75special

Practice Free 300-120 Implementing Cisco Wireless Advanced Solutions (300-120 WLSI) v1.2 Exam Questions Answers With Explanation

We at Crack4sure are committed to giving students who are preparing for the Cisco 300-120 Exam the most current and reliable questions . To help people study, we've made some of our Implementing Cisco Wireless Advanced Solutions (300-120 WLSI) v1.2 exam materials available for free to everyone. You can take the Free 300-120 Practice Test as many times as you want. The answers to the practice questions are given, and each answer is explained.

Question # 6

What must be configured on ISE version 2.1 BYOD when using Single SSID?

A.

open authentication

B.

802.1x

C.

no authentication

D.

WPA2

Question # 7

An engineer completes the setup of a two-node Cisco ISE deployment for a guest portal. When testing the portal, the engineer notices that sometimes there is a certificate CN mismatch. Which certificate type helps resolve this issue?

A.

Public-Signed Root

B.

Public-Signed SAN

C.

Self-Signed Wildcard

D.

Self-Signed Standard

Question # 8

Company XYZ recently migrated from legacy WLCs to Cisco Catalyst 9800 WLCs. According to the global standard, Internet bandwidth must be limited to 5 Mbps for each guest client. To which Cisco Catalyst 9800 WLC configuration component must the QoS requirement be added?

A.

table map

B.

service policy

C.

class map

D.

policy map

Question # 9

A customer has Cisco FlexConnect APs at all remote branches and requires zero downtime through the FlexConnect Fault Tolerance feature. Which two configurations must be identical on both controllers to maintain connectivity when the APs switch from the primary WLC to the backup WLC because of a WAN failure? (Choose two.)

A.

AAA server ordering

B.

mobility domain

C.

interface configuration

D.

WLAN ordering

E.

AP join profile

Question # 10

A network engineer created a new wireless network that will be used for guest access. The corporate network must utilize all rates. The guest network must use only lower rates instead of 802.11n data rates. To what must the WMM policy of the WLAN be set to accomplish this task?

A.

required

B.

allowed

C.

disabled

D.

mandatory

Question # 11

A customer must use deep-packet inspection on the Cisco Catalyst 9800 Series Wireless Controller. The details must include all wireless client use details. Where must AVC be configured to meet this requirement?

A.

RF tag

B.

WLAN

C.

policy profile

D.

join tag

E.

AP join

Question # 12

A retail company has deployed a FlexConnect WLAN with local switching at a small branch location. The Flex profile already includes VLAN 1950 and is mapped to the correct site tag. A specific client must be dynamically assigned to VLAN 1950 by Cisco ISE, and that client’s traffic must be centrally switched to the controller.

Which two configurations must the engineer enable on the controller? (Choose two.)

A.

Enable split tunneling in the local network.

B.

Configure VLAN 1950 as the native VLAN on the AP trunk.

C.

Enable VLAN-based Central switching.

D.

Disable RADIUS override for local-to-central switching.

E.

Enable AAA override.

Question # 13

A wireless engineer must implement a corporate wireless network for a large company in the most efficient way possible. The wireless network must support 32 VLANs for 300 employees in different departments. Which solution must the engineer choose?

A.

Configure a second WLC to support half of the APs in the deployment.

B.

Configure one single SSID and implement Cisco ISE for VLAN assignment according to different user roles.

C.

Configure different AP groups to support different VLANs, so that all of the WLANs can be broadcast on both radios.

D.

Configure 16 WLANs to be broadcast on the 2.4-GHz band and 16 WLANs to be broadcast on the 5.0-GHz band.

Question # 14

What two actions must be taken by an engineer configuring wireless Identity-Based Networking for a WLAN to enable VLAN tagging? (Choose two.)

A.

enable AAA override on the WLAN

B.

create and apply the appropriate ACL to the WLAN

C.

update the RADIUS server attributes for tunnel type 64, medium type 65, and tunnel private group type 81

D.

configure RADIUS server with WLAN subnet and VLAN ID E. enable VLAN Select on the wireless LAN controller and the WLAN

Question # 15

A wireless network uses Cisco ISE to implement 802 1x for user authentication and an Active Directory server as a user database After a power outage, the wireless clients cannot connect to the wireless network The ISE log reports a "clock skew" Which action addresses this issue?

A.

Enter the correct credentials

B.

Restart the ISE service

C.

Install a trusted certificate

D.

Configure NTP

Question # 16

On a Cisco Catalyst 9800 Series Wireless Controller, an engineer wants to prevent a FlexConnect AP from allowing wireless clients to connect when its Ethernet connection is nonoperational. Which command set prevents this connection?

A.

config terminal

wireless flexconnect profile [profile name]

ethernet-fallback-enable

end

B.

config terminal

wireless flexconnect profile [profile name]

fallback-radio-shut

end

C.

config terminal

wireless profile flex [profile name]

fallback-radio-shut

end

D.

config terminal

wireless profile flex [profile name]

ethernet-fallback-enable

end

Question # 17

An engineer completed the basic installation for two Cisco CMX servers and is in the process of configuring high availability, but it fails. Which two statements about the root of the issue are true? (Choose two.)

A.

The Cisco CMX instances are installed in the same subnet.

B.

The types of the primary and secondary Cisco CMX installations differ.

C.

The delay between the primary and secondary instance is 200 ms.

D.

The sizes of the primary and secondary Cisco CMX installations differ.

E.

Both Cisco CMX installations are virtual.

Question # 18

A wireless administrator must assess the different client types connected to Cisco Catalyst 9800 Series Wireless Controller without using any external servers. Which configuration must be added to the controller to achieve this assessment?

A.

native profile

B.

MAC classification

C.

local profile

D.

device classification

Question # 19

In a Cisco WLAN deployment, it is required that all Aps from branch1 remain operational even if the control plane CAPWAP tunnel is down because of a WAN failure to headquarters. Which operational mode must be configured on the APs?

A.

disconnected

B.

standalone

C.

lightweight

D.

connected

Question # 20

What is the Cisco recommended configuration for a Cisco switch port connected to an AP in local mode for optimal voice over WLAN performance with an 8821 wireless phone?

A.

switchport encapsulation dot1q

switchport mode trunk

mls qos trust device cisco-phone

B.

switchport mode access

mls qos trust device cisco-phone

C.

switchport mode access mls qos trust cos

D.

switchport mode access mls qos trust dscp

Question # 21

What must be configured on the Global Configuration page of the WLC for an AP to use 802.1x to authenticate to the wired infrastructure?

A.

local access point credentials

B.

RADIUS shared secret

C.

TACACS server IP address

D.

supplicant credentials

Question # 22

Refer to the exhibit. A network administrator must migrate a Cisco Catalyst 9800 WLC from local client profiling to RADIUS profiling through Cisco ISE. The engineer must enable RADIUS CoA based on detecting the client type as Windows to update the access policy based on profile detection immediately. Which CoA type configuration must the engineer apply on Cisco ISE?

300-120 question answer

A.

no CoA

B.

reauth

C.

port

D.

bounce

E.

preauth

Question # 23

A network engineer must segregate all IPads on the guest WLAN to a separate VLAN. How does the engineer accomplish this task without using Cisco

ISE?

A.

Create a local policy on the WLC.

B.

Use 802.1x authentication to profile the devices.

C.

Use an mDNS profile for the iPad device.

D.

Enable RADIUS DHCP profiling on the WLAN.

Question # 24

A network engineer recently deployed Cisco Catalyst Center (formerly DNA Center) to a customer site. The customer is being flooded with alarms for wireless clients that fail AAA authentication. What is the path to disable the alarm in the Cisco Catalyst Center user interface?

A.

Assurance > Manage > Sensors

B.

Assurance > Manage > Intelligent Capture Settings

C.

Assurance > Manage > Issue Settings

D.

Assurance > Manage > Health Score Settings

Question # 25

What is configured to use more than one port on the OEAP to extend the wired network?

A.

remote LAN ACL

B.

AAA override

C.

client load balancing

D.

remote LAN

Question # 26

An IT team is growing quickly and needs a solution for management device access. The solution must authenticate users from an external repository instead of the current local on the WLC, and it must also identify the user and determine what level of access users should have. Which protocol do you recommend to achieve these goals?

A.

network policy server

B.

RADIUS

C.

TACACS+

D.

LDAP

Question # 27

An organization is supporting remote workers in different locations. In order to provide wireless network connectivity and services, OfficeExtend has been implemented. The wireless connectivity is working, but users report losing connectivity to their local network printers. Which solution must be used to address this issue?

A.

OEAP gateway override

B.

OEAP split tunnel

C.

WLAN static IP tunneling

D.

FlexConnect local switching

Question # 28

A retail chain is deploying a wireless network across multiple branch stores using Cisco Catalyst 9800 Series controllers and access points in FlexConnect mode. The employee WLAN uses WPA2-PSK and must remain available during WAN outages while still being centrally managed when WAN connectivity is available.

Which two actions should the network administrator implement to support this design? (Choose two.)

A.

Centralize all authentication at the controller and rely on cached credentials at the APs during outages.

B.

Configure the controller to centrally switch the employee WLAN traffic at all times.

C.

Install a local RADIUS server at each branch to authenticate WPA2-PSK users.

D.

Group the FlexConnect APs by branch in a FlexConnect group so branch-specific settings can be applied.

E.

Configure the FlexConnect APs to locally switch the employee WLAN traffic.

Question # 29

A corporation has a wireless network in which all APs are configured in FlexConnect mode. The WLC has a data WLAN and a VoWiFi WLAN, and both SSIDs are centrally switched. Which QoS configuration must be implemented so that wireless packets maintain their markings across the wired and wireless networks?

A.

IPP

B.

CoS

C.

DSCP

D.

WMM UP

Question # 30

A customer must provide remote users with secure wireless access through a Cisco Catalyst 9800 Series Wireless Controller and Cisco APs. The corporate WLAN must be extended over the Internet to specific locations and support a locally installed IP phone.

Which two actions accomplish this configuration? (Choose two.)

A.

Enable OfficeExtend AP on the Flex profile.

B.

Create a FlexConnect group and add the AP.

C.

Configure NAT on the physical interface.

D.

Enable Local Switching under the WLAN.

E.

Configure a remote LAN under the Remote LAN settings.

Question # 31

When the Cisco FlexConnect AP Image Upgrade feature is used, APs must communicate with each other to distribute the image. Which two elements are required for this feature to work when the APs are on different subnets? (Choose two.)

A.

Configure routing so that the APs can reach the core switch.

B.

Disable peer-to-peer blocking.

C.

Connect the APs to the same switch or switch stack.

D.

Configure routing and switching between APs on different subnets.

E.

Allow communication between the APs through the firewall.

300-120 PDF

$35

$139.99

3 Months Free Update

  • Printable Format
  • Value of Money
  • 100% Pass Assurance
  • Verified Answers
  • Researched by Industry Experts
  • Based on Real Exams Scenarios
  • 100% Real Questions

300-120 PDF + Testing Engine

$47.5

$189.99

3 Months Free Update

  • Exam Name: Implementing Cisco Wireless Advanced Solutions (300-120 WLSI) v1.2
  • Last Update: Nov 22, 2026
  • Questions and Answers: 105
  • Free Real Questions Demo
  • Recommended by Industry Experts
  • Best Economical Package
  • Immediate Access

300-120 Engine

$40

$159.99

3 Months Free Update

  • Best Testing Engine
  • One Click installation
  • Recommended by Teachers
  • Easy to use
  • 3 Modes of Learning
  • State of Art Technology
  • 100% Real Questions included