3 Months Free Update
3 Months Free Update
3 Months Free Update
Refer to the Exhibit.
A customer has asked you to perform a port failover test to demonstrate system resiliency. What is needed to complete this task?
What is the correct sequence of steps to enable MPIO on a Microsoft Windows 2012 Server?
A customer wants to configure a threshold alert definition. Which types of definitions can be configured?
During the addition of an SCv360 enclosure to a SCv3020 the PCle SAS card is used for connectivity. The enclosure is NOT recognized by the system, why?
You are about to perform the post-setup tasks with the Storage-Center wizard. What information is required before proceeding?
You are deploying a new SC9000 system running Storage Center OS 7.2. At which drive size does the system require you to begin running dual redundancy on both SSDs and HDDs?
A customer is using an SC8000 array with three chained SC220 expansion enclosures on a single card. They need to expand its capacity by adding an SC280 enclosure. How should the new expansion enclosure be connected using a minimum number of chains?
What is order of steps that the Storage Center will follow when it senses that the UPS has lost input power?
What is the correct sequence of steps to present a volume to an ESXi host?
A customer wants to add an SC420 and an SC200 to a SC7020 storage array. What is the recommended approach to adding the new enclosures?
You are required to install twenty-four (24) 3.5” 12 Gb disks on a deployed system. Which disk enclosure would support this?
You have implemented two SC Series systems at a customer site. The Dell Storage Manager (DSM) Suite has been installed on a Microsoft Windows server. Both Storage Centers have been installed and added to the DSM. However, several days after the installation, the customer is only able to see one Storage Center in the DSM GUI.
Which recommended action will correct this issue?
After the implementation of a DR site with Synchronous replication all applications were up and running fine. The restore points were saved and validated; DR was predefined and successfully tested. Sometime later, one of the applications became unresponsive and initial troubleshooting points to Storage/Volume as the root cause.
Concerning the Replication to the DR site, what could be happening?
Which operating system runs the Dell Storage Manager (DSM) as a virtual appliance?