3 Months Free Update
3 Months Free Update
3 Months Free Update
An administrator needs to relocate an AHV cluster to a new datacenter during a maintenance window. The cluster will use the same IPs in the new datacenter.
Which two steps should be taken to prepare for this task? (Choose two.)
A customer has a Nutanix cluster with 10Gb connectivity via switch fabric extenders. The administrator receives NCC health check errors of latency greater than 200ms.
Which action should the administrator take to resolve the NCC errors?
An administrator needs to expand a nutanix cluster that is tagging the network traffic at the CVM and AHV level, however the administrator doesn't remember the configured VLAN ID.
Which AHV command can the administrator run to find the correct VLAN ID?
An administrator is concerned that Prism will be inaccessible if Active Directory is unable to process logins. Which method should the administrator use to access the cluster in the event of this type of outage?
An Administrator expanded the disk capacity on a windows VM, but the VM operator saw no difference in its space.
Which Addition task must the administrator take ?
An administrator is deploying Nutanix Files 3.5 and needs to configure the sizing of the FSVMs for an increased number of concurrent SMB connections over the default 750.
What should the administrator do?
An administrator receives an alert in Prism indicating that interface eth2, on an AHV host is receiving many CRC errors. After togging into the problematic host, the following command is run to show the indicated output:
What is causing this issue?
An administrator recently added in 3 nodes to an existing 5 node cluster. While 1 node came with its own block, the other 2 nodes where added to an existing share. After adding the nodes, the administrator sees that the hardware tab displays the correct number of nodes, but incorrect position in the diagram tab.
What should the administrator do to resolve the issue?
Assuming Sufficient Storage Capacity, how long are entities kept in the prism recycle bin?
An administrator needs to provide data integrity at the application level for a VM that is replicated to a secondary site.
Which requirement will satisfy this task?
Refer to the exhibit.
An administrator is commissioning a Nutanix Enterprise Cloud. Once the user VMs have been deployed and are running, the administrator finds that VMs on the same host are able to communicate, but are unable to communicate between hosts.
What must be changed to enable full inter-VM communications?
Refer to the exhibit.
An administrator configures Active Directory authentication as shown in the exhibit. Upon finishing setup, users are not able to log in.
What configuration change should be made to fix this issue?
A guest VM is reported to have poor storage performance. It has an I/O profile of 80% read. 20% write, and the HDDs form more than 50% of the read source.
What should an administrator do to resolve this issue?
A systems administrator configures a protection domain replication between two Nutanix clusters. After the first successful replication, the administrator tests DR by clicking activate on the remote cluster.
While VMs are active on the remote cluster, the protection domain is marked as active on both clusters.
What steps are required to return both clusters to their original state?
An application owner had reported that an AHV - based critical application VM is performing very slowly, after initial diagnostics is has been observed that the CPU utilization is significantly higher than normal.
What two actions should the administrator take on this VM without shutting it down? choose two.
An Administrator has received the following critical alert:
Node 192.168.148.172 is marked to be detached from metadata the administrator has opened a case with Nutanix and the support engineer has requested more information about the error. Which two action should the administrator take in the health check dashboard to collect the requested information? choose two
An administrator has been tasked with delivering a report on all nutanix Field Advisors (FAs) Affecting each of the clusters.
What is the most efficient way to collect this data?
An administrator is deploying several new application VMs to a Nutanix cluster. The application is very transactional with a 28/72 random, read/write ratio.
What should the administrator do?