Score Higher on Verified QREP | Qlik Replicate Certification Exam Questions with Answers

Theattrep_apply_exceptionstable in Qlik Replicate is used for troubleshooting specific issues that occur during the data replication process. Based on the documentation and community discussions, the two situations where this table can be particularly useful are:

Apply conflicts (B): This table records errors related to conflicts that occur when applying changes to the target system.For instance, if there is a primary key violation or a constraint failure, the details of the conflict are logged in this table1.

Data errors (E): The table also captures errors related to the data itself, such as missing data or data type mismatches.If a record cannot be applied due to data-related issues, the error message and the statement that caused the error are stored in theattrep_apply_exceptionstable2.

Theattrep_apply_exceptionstable is not typically used forabnormal termination (A),table errors ©, orenvironment errors (D)as these issues are generally logged elsewhere within the system or require different troubleshooting approaches. For example, abnormalterminations might be logged in system event logs, while environment errors could be related to infrastructure issues outside the scope of Qlik Replicate’s control tables.

When a new column is added to one of the tables in a Qlik Replicate task, the administrator should stop and then resume the task to replicate this change. This process allows Qlik Replicate to recognize the structural change and apply it accordingly.

The steps involved in this process are:

Stop the task: This ensures that no data changes are missed during the schema change.

Resume the task: Once the task is resumed, Qlik Replicate will pick up the DDL change and apply the new column to the target system.

This procedure is supported by the Qlik Replicate’s DDL handling policy, which can be set to perform an “alter target table” when the source table is altered.This means that when the task is resumed, the new columns from the source tables will be added to the Replicate target1.

It’s important to note that while stopping and resuming the task is generally the recommended approach, the exact steps may vary depending on the specific configuration and version of Qlik Replicate being used. Therefore, it’s always best to consult the latest official documentation or support resources to ensure the correct procedure for your environment.

Questions no:21Verified Answer: = C. As close as possible to the source system

Step by Step Comprehensive and Detailed Explanation with all References: =In an on-premises environment, Qlik Replicate should be set up as close as possible to the source system. This is because the source system is where the initial capture of data changes occurs, and having Qlik Replicate close to the source helps to minimize latency and maximize the efficiency of data capture.

C. As close as possible to the source system: Positioning Qlik Replicate near the source system reduces the time it takes to capture and process changes, which is critical for maintaining low latency in replication tasks1.

The other options are not recommended because:

A. As close as possible to the target system: While proximity to the target system can be beneficial for the apply phase, it is more crucial to have minimal latency during the capture phase, which is closer to the source.

B. In the “middle” between the source and target: This does not provide the optimal configuration for either the capture or apply phases and could introduce unnecessary complexity and potential latency.

D. In a cloud environment: This option is not relevant to the question as it specifies an on-premises setup. Additionally, whether to use a cloud environment depends on the specific architecture and requirements of the replication scenario.

For detailed guidance on setting up Qlik Replicate in an on-premises environment, including considerations for placement and configuration to optimize performance and reduce latency, you can refer to the official Qlik Replicate Setup and User Guide1.