3 Months Free Update
3 Months Free Update
3 Months Free Update
What are the minimal policy directive(s) to ensure all components of a Windows server system are protected when performing a backup?
Refer to the Exhibit.
Which diagram is supported for backups spanning BasicDisk storage?
Which restore method enables simplified search and retrieval across multiple NetBackup domains?
Several clients in the same network experience consistent, short-term network failures. The clients are sending data to a media server using a storage unit group. The network failures are causing job failures.
Which setting reduces the job failures in this situation?
Refer to the Exhibit.
An administrator is trying to access client properties on the NetBackup Administration Console and receives the following message:
When checking the services on the master server, the administrator sees that the PBX service is down.
Which two commands can the administrator use to increase the PBX log level to determine the reason for the message above? (Choose two.)
A NetBackup master server has many backups running each night to an MSDP pool that take a long time to complete. While these backups are running, replication jobs are queued.
Which action should the administrator perform to ensure replications can occur without waiting for the backups to complete?
A BasicDisk storage unit is 500GB and is running out of space.
The disk and file system is resized to 800GB. What must occur to use this new disk space?
Which method is NOT able to provide performance information for previously run backup jobs?
Prior to initiating a restore, an administrator realizes that media needed for the restore was written by a server that is unavailable. The administrator does have another server that can perform the restore and that is connected to the same library.
Which two commands can the administrator perform to change the server ownership, so the restore can be performed? (Choose two.)
An image of the volume past is expiration date or has reached its maximum number of mounts is no longer available for restores.
An administrator has an environment that runs over one thousand jobs a night. Some nights there are hundreds of jobs queued waiting for a resource.
Which action should the administrator take in the event that specific queued jobs need to run when a resource next becomes available during that evening’s backup session?
A tape library had the robot firmware upgraded, and now the robot is reading the barcodes with additional characters.
How should an administrator enable NetBackup to use the same characters that were used before the firmware upgrade?
Refer to the exhibit.
A backup policy uses a Full backup schedule with a schedule type of Frequency: 1 day. The start window for the schedule is configured as shown in the exhibit:
The administrator runs a manual backup at 10:00 on Thursday.
When will the next backup run, if all prior backups completed successfully?
Consider the configuration information for a single UNIX client displayed below.
Allow Multiple Data Streams is enabled. ALL_LOCAL_DRIVES is specified. Media multiplexing is set to 6.
Three tape drives are available in the storage unit and multiplex per drive is 2. Max Jobs per Client is set to 8.
The client has five local file systems with no exclude list.
How many concurrent data streams will there be when the policy runs?
To reduce network use by limiting the number of parallel backup streams, which cloud setting should be modified under the Scalable Storage host property?
An AdvancedDisk storage unit consistently reaches capacity, causing older, staged backups to expire.
How can the administrator control the prioritization of images that get removed?
Which command should an administrator use to show a list of incomplete copies of lifecycle managed images?
Backup jobs to an MSDP storage unit of a large EXT3 file system for a Linux client connected via a 1 GbE network are taking excessive time.
Which two settings should an administrator change to improve the performance of the backups? (Choose two.)
When NetBackup makes more than one image copy simultaneously during the backup, it is called
.
Which disk type is unsupported in a Media Server Load Balancing storage unit group?
An administrator has a scheduled policy that backs up 20 clients, each with multiple mount points and multiple data streams enabled. One of the jobs has failed and is in an Incomplete state in the Activity Monitor.
How should the administrator verify the incomplete job runs prior to the next scheduled backup?
Refer to the exhibit.
The following Storage Lifecycle Policy was used to back up data from a client. All duplication jobs have completed, and none of the backups have expired.
How should an administrator restore data from the tape using NetBackup?
An administrator has a backup policy with the following policy attributes:
3 paths listed in the Backup Selections list 5 clients listed in the Clients list
"Allow multiple data streams" is selected "Limit jobs per policy" is set to 4
How many jobs go Active when the job is started, excluding parent jobs, assuming there are enough storage resources to handle the expected jobs?
Backups to a storage device fail with the following error message:
Disk storage server is down (2106)
The storage server is an OpenStorage (OST) host, and the master server and media server are both acting as media servers under Credentials > Storage Servers in the NetBackup Administration Console. The disk pool is in an Up state and the storage server is in a Down state. Troubleshooting confirmed the OST plug-ins on the servers are mismatched.
Which command should an administrator use to check the plug-in version installed on the servers?
To which VMware component does the backup host require direct access for SAN backups?
Upon arriving at work on a Monday, an administrator sees several replication jobs that have failed with the following error message:
no images were successfully processed
Which two reasons may be the cause for the error code? (Choose two.)
Which storage unit group selection causes NetBackup to choose the least recently selected storage unit in the list as each new job is started?
A restore using the Java BAR is being attempted. Care has been taken to select the appropriate source client, but no backup image content is displayed.
What could be a reason for this to happen?
Where in the Backup, Archive, and Restore interface on a Microsoft Windows Client would an administrator define the source client for a restore job?
An administrator is creating a Standard policy with the option ''Use Accelerator'' to back up files on a Linux server.
Which two options are disabled by default in this type of policy? (Choose two.)
An administrator working offsite is required to carry out a major upgrade to a NetBackup appliance. The appliance will need to be rebooted multiple times during the upgrade process.
How should the administrator connect to the appliance to monitor the upgrade progress without interruption?
A volume is no longer used for backups if it is past its expiration data or has reached its maximum number of mounts.
A file system on a server that has different files changing daily becomes corrupt, and a restore is required. The system is being backed up using True Image Restore with move detection enabled.
The most recent backups of this file system are displayed below:
What is the minimum number of backup images that will be used to fully restore the server to its most current state?
Where can an administrator change a disk pool to Down status in the NetBackup Administration Console?
What must be confirmed during an interactive installation or upgrade to ensure certificate deployment is secure?
Which two NetBackup features are available to protect the MSDP catalog? (Choose two.)
To create a load balancing media server, you must first configure it as a storage server.
Refer to the Exhibit.
An administrator has created a policy that has three new Full schedules as shown in the exhibit. All the schedules are set to run on Friday, from 0200 to 0600.
What is the order of priority for the schedules on Friday?
An administrator has backups for a Linux client that are failing with the following error message:
Status 58: can't connect to client
Which command should the administrator use to identify why the media server is unable to connect to the client?
Which two prerequisites must an administrator perform to allow restoration of individual objects and attributes in Active Directory? (Choose two.)
An administrator of a multi-site, multi-domain NetBackup environment wants to be able to provide redundancy for backups as well as protecting the NetBackup image database. All backups must have on-site and off-site copies in multiple NetBackup domains as well as off-site tape copies.
Which NetBackup feature should the administrator use to implement the functionality?
Some NetBackup jobs are affected by the failure of a disk in an AdvancedDisk pool, but the jobs are unavailable to view in the Activity Monitor.
In which two places can the administrator view NetBackup jobs affected by the disk failure? (Choose two.)
Which schedule can be configured as a synthetic backup in addition to the full backup schedule type?
The NetBackup Resource Broker (NBRB) maintains resource requests for jobs that are queued.
Which two criteria does NBRB use to evaluate the resource requests and provide resources to each job sequentially? (Choose two.)
What is the certificate deployment and management behavior when the security level is set to High?
What is the maximum number of policies that NetBackup can be configured to use?
An administrator has a job that has failed. Upon reviewing the Detailed Status tab for the job, the administrator sees the following information:
Which setting value prevented the job from running during the backup window?
The Activity Monitor shows a failed job. Which method is easiest to troubleshoot the error code?
When troubleshooting backup operation issues, which status code indicates that the start window was closed?