Crack4sure Logo
Exhibit:
Which two statements regarding the output shown in the exhibit are correct? (Choose two.)
Exhibit:
Referring to the exhibit, you need to implement VPLS between CE-A1 and CE-A2 You must ensure that no loops are created due to the multihoming of the connection from CE-A2 to PE2 and PE3.
Based on the type of VPLS, which two solutions will satisfy this requirement? (Choose two.)
Exhibit:
You have an established Layer 3 VPN between two PE devices. You are asked to only send certain routes from PE-1 over the VPN to the remote site while maintaining all the routes on the PE-1 device. You created a policy that matches the specific routes and then tags these routes with the appropriate target community values.
In this scenario, which configuration changes must be made to satisfy the requirement?
Exhibit.
You are provisioning Layer 2 circuits between sites CE1. CE2. andCE3
Referring to the exhibit, which statement is true?
You are creating an LDP-signaled Layer 2 circuit between two sites. Site1 and Site2 use different VLAN IDs to connect to your PE devices In this scenario, which encapsulation type must be used on the logical interfaces?
Exhibit:
The exhibit shows a BGP peering session for two PE routers. The BGP session is up, but the hosts in the Layer 2 VPN that uses the BGP session are unable to communicate.
What is the problem in this situation?
Exhibit:
You are receiving the same 200.0.0.0/24 BGP route from four different ISPs.
Referring to the exhibit, which ISP's route would be selected as active?
Exhibit:
A network administrator is concerned about the number of LSAs that they are observing on the network.
What will reduce Type 7 LSAs advertised from R2 to the non-backbone routers shown in the exhibit?
TESTED 23 Apr 2024